Check out my new site: FreeDaBeat.com!

Set Bender Range

Read and write articles, faq's, tips/tricks, tutorials and other forms of helpful information about the Gaia.

Set Bender Range

Postby rob » Wed Dec 14, 2011 6:31 am

This is in the manual, but I had to dig it up the other day to figure this out. So here it is for the next time i forget.

1. While holding down the [CANCEL/SHIFT] button, move the pitch bend/modulation lever all the way to the far left or right.
The OCTAVE [DOWN/-] and [UP/+] buttons will blink.

2. While holding down the OCTAVE [DOWN/-] button, press a key (C2–C4).
This specifies the amount of pitch change that will occur when you move the lever to the left.
C2 Narrow – Range of change – Wide C4

3. While holding down the OCTAVE [UP/+] button, press a key (C2–C4).
This specifies the amount of pitch change that will occur when you move the lever to the right.

4. When you’ve finished making settings, press the [CANCEL/SHIFT] button.
rob
 
Posts: 65
Joined: Tue Dec 14, 2010 5:01 am

Return to Articles and Tutorials

Who is online

Users browsing this forum: No registered users and 1 guest

cron